Explanation:
Primary Array:
* Drag and drop two 120 GB SSD hard drives to the primary array bay.
* Open the primary array and select RAID 1 as the RAID level. RAID 1 provides fault tolerance of one drive, ability to function with only one drive, easily recoverable data, high redundancy, and very fast on reads. It also does not need to be scalable and uses the minimum number of drives (two) for RAID 1.
* Confirm the configuration and close the primary array.
Secondary Array:
* Drag and drop two 300 GB SSD hard drives to the secondary array bay.
* Open the secondary array and select RAID 0 as the RAID level. RAID 0 provides the best write performance and uses the minimum number of drives (two) for RAID 0. It also provides a total space of
600 GB (300 GB x 2), which meets the requirement.
* Confirm the configuration and close the secondary array.
You have completed the configuration of the storage arrays.

The correct answer is D. Cat 6a.
Cat 6a (augmented) is a type of twisted pair cable that supports 10GBASE-T data transmission speed.
10GBASE-T is an Ethernet standard that can deliver 10 gigabits per second (Gbps) over copper cables. Cat 6a can support this speed up to a distance of 100 meters, which is the same as Cat 5e and Cat 6 for lower speeds.
Cat 6a has better shielding and crosstalk prevention than Cat 6, which makes it more suitable for high-frequency signals.
Cat 3, Cat 5, and Cat 5e are not capable of supporting 10GBASE-T data transmission speed. Cat 3 can only support up to 10 Mbps, Cat 5 can only support up to 100 Mbps, and Cat 5e can only support up to 1 Gbps.
These cables have lower bandwidth, higher attenuation, and more interference than Cat 6a.
Reference: Network Cables - CompTIA A+ 220-1101 - 3.1 - Professor Messer IT Certification Training Courses

Cat 5 cable is limited to a maximum data transfer rate of 100Mbps, while Cat 5e, Cat 6, and Cat 6a cables support Gigabit Ethernet (1000Mbps) and higher speeds. Even though the LAN card is capable of Gigabit speeds, it cannot achieve that speed when using a Cat 5 cable. Upgrading to a Cat 5e or higher cable would allow the computer to achieve Gigabit speeds. References: CompTIA A+ Certification Exam: Core 1 - Page
196

Following corporate procedures would have been the most likely factor that could have prevented the technician from receiving the written warning. Following established procedures, such as change management, helps ensure that changes made to the production environment are thoroughly tested, approved, and implemented in a controlled and safe manner, reducing the risk of system-wide outages and other unintended consequences.

A hypervisor is a software layer that manages and allocates resources for virtual machines (VMs) on a physical host machine. A technician can use a hypervisor to adjust the resource allocation for a virtual workstation, such as increasing the amount of RAM assigned to it from the available pool of memory on the host machine. This can improve the performance and functionality of the virtual workstation without requiring any hardware changes or modifications. Reference:
https://www.comptia.org/training/books/a-core-1-220-1101-study-guide (page 59)