A company is redesigning its office to remove the divider walls between desks and create an open collaboration area. All network cables are run through the divider walls, and a new wireless network will be installed. Which of the following sets of documents will need to be revised based on the new configuration?

A technician needs to add ten additional Ethernet ports to a small office network. A new basic function switch Is added. Hosts connected to the new switch are unable to see any computers on the network other than those connected to the new switch. Which of the following should the technician perform to ensure the hosts on the new switch can communicate with the existing network?

A network field technician is installing and configuring a secure wireless network. The technician performs a site survey. Which of the following documents would MOST likely be created as a result of the site survey?

Your company recently purchased a new building down the street from the existing office. For each of the tasks below, select the appropriate antenna type and encryption object for all wireless access point (AP).
1. Create an encrypted wireless connection between the two buildings that BEST controls signal propagation, while maximizing security.
2. Restrict the wireless signal generated by the access points (APs) inside Building 1, so that it minimizes broadcast beyond the building.
3. Maximize wireless coverage inside Building 1.
4. Building 1's internal wireless network is for visitors only and must not require any special configuration on the visitor's device to connect.

Instructions: When you have completed the simulation, select the Done button to submit.

You have been tasked with testing a CAT5e cable. A summary of the test results can be found on the screen.
Instructions
Step 1: Select the tool that was used to create the cable test results.
Step 2: Interpret the test results and select the option that explains the results. After you are done with your analysis, click the 'Submit' button.
If at any time you would like to bring back the initial state of the simulation, please click the Reset All button.