Online Access Free DCPPE-200 Exam Questions

A VRTX has the following physical disks:
- 8 300 GB SSDs
- 10 300 GB 15,000 rpm HDDs
An engineer needs to create two virtual disks for a file server: a system volume and a data volume.
The customer wants to maximize performance of the system volume and maximize redundancy of the data volume.
The customer also wants both virtual disks to survive one drive failure without the customer's intervention.
Which option is most appropriate to meet the requirements?

• A.System: 8 SSDs in RAID 10Data: 8 HDDs in RAID 6Two HDDs as dedicated hot spares for each volume
• B.System: 6 SSDs in RAID 10Data: 10 HDDs in RAID 6Two SSDs as dedicated hot spares for each volume
• C.System: 7 SSDs in RAID 5Data: 9 HDDs in RAID 6One SSD and one HDD as dedicated hot spares for each volume
• D.System: 7 SSDs in RAID 0Data: 9 HDDs in RAID 6One SSD and one HDD as dedicated hot spares for each volume

An engineer is running an inventory report on a VRTX chassis group for a customer. When the engineer views the report, the engineer notices the inventory of one of the VRTX is missing one of its nodes.
What is the cause?

• A.The node's iDRAC needs to have an Enterprise license installed.
• B.The VRTX group member is in Chassis Power State Off since the node was inserted.
• C.The VRTX group member is disconnected from the network at the time of the report.
• D.The node's iDRAC is unreachable from the VRTX group leader's CMC.

An engineer is configuring VLT between two MXL switches. The engineer runs a show vlt brief command on one of the MXLs and receives the status shown in the exhibit. What should the engineer verify to fix the issue?

• A.Both MXLs are powered on and fully booted into the OS
• B.VLT cables are plugged in and have a link light
• C.Both MXLs run the same firmware version
• D.MXLs can ping each other on their management IPs

An engineer is installing a known good PCIe storage adapter in SLOT 1 of an FX2 chassis with four half height nodes. Node 1 is NOT detecting the adapter.
What must the engineer do so that node 1 can detect the adapter?

• A.Move the adapter to SLOT 7
• B.Power off node 1
• C.Assign SLOT 1 to node 1 in the CMC
• D.Perform virtual reseat of the adapter

A customer has a VRTX with Shared PERC External cards cabled as shown in the exhibit. Which connection needs to be swapped to fix the cabling?

• A.EMM0_Out with EMM1_Out
• B.EMM0_In with EMM0_Out
• C.EMM1_In with EMM1_Out
• D.EMM0_In with EMM1_In