A user has a drive failure on a server with four identical drives configured in a RAID 5 setup and no spare. The technician arrives and switches the bad drive with an identical new drive and completes a rebuild. A month later the user complains that the RAID configuration is a little slower than it was before the failure.
What action should the technician take?

A company has an existing Dell EMC 4-node X410 Gen 5 cluster with approximately 100TB of SMB shares connected using two InfiniBand 8-port switches.
The company wants a technical refresh of the cluster with a new 4-node H500 Gen 6 cluster with two 16- port InfiniBand switches. The existing cluster has SyncIQ, SmartConnect Advanced, and SmartPools licenses installed.
To move the data from the existing modes to the new nodes, which migration plan is recommended?

A technician installs a server with a network daughter card (NDC). The NDC has two 10Gb BaseT ports as well as 1Gb BaseT ports. The technician is using the correct CAT- 6 network cable and a 10Gb switch. The server reports 1Gb connections on ports 3 and 4. Ports 1 and 2 are down.
How should the technician get 10Gb connectivity?

A technician needs to configure a server to allow the OS to manipulate processor frequencies for higher power efficiency.
How should the technician perform this task?

A technician needs to install a server with a PERC RAID controller and 24, 2.5" SAS SED drives.
The installation requires the following items to be created:
- Three equal-sized virtual disks
- Encrypted virtual disks
- A global hot spare
In addition to selecting the physical drive to be the hot spare disk, what tasks should the technician perform to set up the RAID controller?