Online Access Free DES-4121 Exam Questions

A sever is configured with a RAID 5 Virtual Disk across live hard disks and one spare disk.
If a hard disk failure occurs within me RAID 5 virtual disk. The spare disk needs to be online as quickly as possible II is acceptable for users to expense decreased performance during the rebuild procedure.
How should Wits requirement be met?

• A.Change cache to Write Through
• B.Enable Rebuild Priority
• C.Select Fast Rebuild
• D.Increase Rebuild Rate

Before deploying a server, a customer needs a technician the front panel LCD to display a customer message that contains the customer's help desk phone number. However, the server cannot be rebooted Where can the technician configure the LCD?

• A.iSM
• B.iDRAC web GUI
• C.System BIOS
• D.Lifecycle Controller

A technician is working on an operational PowetEdge R640 server that cannot be rebooted Observing that all the drives are hot-swappable devices, the technician decides to remove a drive that has boon giving intermittent errors. After the single drive is removed the operating system crashes What could have caused the operating system to crash?

• A.iDRAC was not configured for hot-swapped components
• B.PERC was not contoured to allow a single drive removal
• C.System Lockdown mode was enabled, which does not allow any component to be hot- swapped
• D.Drive was pad of a RAID 0 virtual disk

After a disk rebuild operation, a technician needs to configure the system so that the rebuild process happens faster in the future, even at the expense of stowing users down How should the technician perform this task?

• A.Change the System Profile to Performance in the System BIOS Setting
• B.Change the System Profile 1o performance in the iDRAC GUI
• C.Change the Rebuild Rate in the System BIOS Settings
• D.Change the Rebuild Rate from me iDRAC GUI

A technician needs to connect a server to a network switch the network switch has only two available network ports so only two network cables can be connected. The user needs as much bandwidth as possible for their workload so the two network cables need to connect to LOM1 and 10M2 The technician wants to satisfy the user requirements yet still be able to access the iDRAC.
What is the best way to configure the iDRAC?

• A.Set up a shared LOM with LOM1 as the NIC selection
• B.Use a splitter cable in one the network switch ports lo connect the same coble lo both LOM1 and the iDRAC Defeated NIC
• C.Use a dedicated cable m one of the network switch ports to connect the same cable lo both LOM 1 and LOM2 with the second network cable connecting lo the iDRAC Dedicated NIC
• D.Set up a dedicated NIC with LOM1 as the NIC selection