When re-licensing an LTM device from the command line interface, which tmsh command should the LTM Specialist use to generate the required information to provide on the F5 licensing portal?

-- Exhibit -


-- Exhibit --
Refer to the exhibits.
How should the LTM Specialist minimize the configuration?

-- Exhibit-

-- Exhibit --
Refer to the exhibit.
Which step should an LTM Specialist take next to finish upgrading to HD1.3?

-- Exhibit - -- Exhibit -


Refer to the exhibit.
An LTM Specialist is troubleshooting an HTTP monitor that is marking a pool member as down. Connecting to the pool member directly through a browser shows the application is up and functioning correctly.
ltm monitor http http_mon { defaults-from http destination *:* interval 5 recv "200 OK" send "GET /\\r\\n" time-until-up 0 timeout 16
}
What is the issue?

An LTM Specialist has just manually failed the active LTM device over to the standby LTM device. The LTM Specialist notices the newly active LTM device is NOT currently receiving traffic. The LTM Specialist verifies the newly active device is responding to ARP but still no traffic is hitting the virtual servers. The LTM Specialist also notices that the virtual servers eventually start responding.
What should be added to the configuration to resolve the problem?