Online Access Free 303 Exam Questions

An F5 LTM Specialist needs to perform an LTM device configuration backup prior to RMA swap.
Which command should be executed on the command line interface to create a backup?

• A.tmsh save /sys config ucs /var/tmp/backup.ucs
• B.tmsh save /sys ucs /var/tmp/backup.ucs
• C.tmsh save /sys config /var/tmp/backup.ucs
• D.bigpipe config save /var/tmp/backup.ucs

The owner of a web application asks the 8IG-IP Administrator to change the port that the BIG-IP device sends traffic to. This change must be made for each member in the server pool named app_pool for their Virtual Server named app_vs. In which area of the BIG-IP Configuration Utility should the BIG-P Administrator make this change?

• A.Local Traffic > Virtual Servers
• B.Network > Interfaces
• C.Local Traffic > Pools
• D.Local Traffic > Nodes

-- Exhibit -

-- Exhibit --
Refer to the exhibit.
A layer 2 nPath routing configuration has been deployed. A packet capture contains a client connection packet with the following properties:
Source IP: <Virtual Server>
Destination IP: <Client A>
At which two locations could the packet capture have been taken? (Choose two.)

• A.the DMZ interface of the Internet firewall
• B.the network interface of web server
• C.the external VLAN interface of the LTM device
• D.the internal interface of the Internet firewall

-- Exhibit -

-- Exhibit --
Refer to the exhibit.
An LTM Specialist is troubleshooting a sync-failover group of three BIG-IP LTM devices. The command used is "tmsh run cm watch-devicegroup-device." What does the output mean?

• A.Configuration is not synchronized. Some modifications have been done on bigipB.
• B.Configuration is not synchronized. Some modifications have been done on bigipA.
• C.Configuration is synchronized between all the devices.
• D.Configuration is not synchronized. Some modifications have been done on bigipC.

A BIG-IP Administrator finds the following log entry after a report of user issues connecting to a virtual server:
01010201: 2: Inet port exhaustion on 10.70.110.112 to 192.28.123.250:80 (proto 6) How should the BIG-IP Administrator modify the SNAT pool that is associated with the virtual server?

• A.Add an address to the SNAT pool.
• B.Increase the timeout of the SNAT addresses.
• C.Remove an IP address from the SNAT pool.
• D.Remove the SNAT pool and apply SNAT Automap.