Online Access Free FCSS_LED_AR-7.6 Exam Questions

Why is it critical to maintain NTP synchronization between FortiGate and FortiSwitch when FortiLink is configured?

• A.To facilitate synchronization of firmware updates across devices
• B.To ensure accurate time for logs, authentication, and event correlation
• C.To allow FortiSwitch to communicate with other FortiSwitche devices in the network.
• D.To allow FortiSwitch to function in standalone mode if FortiGate becomes unavailable

Why is the suppression of rogue APs becoming more difficult with the introduction of new wireless security standards, such as 802.11w?

• A.802.11w encrypts all data traffic, making it difficult to identify rogue APs through packet inspection.
• B.802.11w increases the processing overhead on network devices, slowing down the detection of rogue APs.
• C.802.11w requires that clients authenticate management frames as legitimate, which helps prevent spoofing attacks.
• D.The 802.11w standard reduces the range of wireless signals, limiting the ability to detect rogue APs at a distance.

Refer to the exhibits.


A NAC policy has been configured to apply traffic that flows through FortiSwitch port 2. Traffic that meets the NAC policy criteria will be assigned to the Students VLAN. However, the NAC policy does not seem to be taking effect.
Which configuration is missing?

• A.Port2 Access mode should be set to Port Policy mode.
• B.The MAC address or OS might be misconfigured for the connected device.
• C.The Students VLAN should be set to Allowed VLANs instead of Native VLAN.
• D.Port2 Access mode should be set to NAC mode.

You need to optimize your wireless network to improve performance and reliability in a dynamic environment. The network must adapt to changes in the radio frequency (RF) environment, such as interference, new devices, and fluctuating traffic patterns.
Which role does FortiAIOps play in monitoring and automatically adjusting to changes in the radio frequency (RF) environment?

• A.To increase the signal strength of the network if required by modulating power levels on all access points
• B.To limit the number of devices connected to each access point in a given area
• C.To detect and report interference and congestion, helping to optimize wireless performance and coverage
• D.To monitor network traffic and recommend firewall rules in real time

Your office wants to set up a Wi-Fi network for visitors. Your company would like to require them to log in for tracking purposes.
Which two types of captive portals could be enabled on an interface? (Choose two.)

• A.Email Notification Only
• B.Authentication
• C.Disclaimer + Authentication
• D.Terms Acknowledgement Without Authentication
• E.Guest Pass Access