Online Access Free FCSS_SDW_AR-7.4 Exam Questions

Refer to the exhibits. An administrator is testing application steering in SD-WAN. Before generating test traffic, the administrator collected the information shown in the first exhibit. After generating GoToMeeting test traffic, the administrator examined the corresponding traffic log on FortiAnalyzer, which is shown in the second exhibit.
The administrator noticed that the traffic matched the implicit SD-WAN rule, but they expected the traffic to match rule ID 1.
Which two reasons explain why some log messages show that the traffic matched the implicit SD- WAN rule? (Choose two.)

• A.Full SSL inspection is not enabled on the matching firewall policy.
• B.The session 3-tuple did not match any of the existing entries in the ISDB application cache.
• C.FortiGate could not refresh the routing information on the session after the application was detected.
• D.No configured SD-WAN rule matches the traffic related to the collaboration application GoToMeeting

Your FortiGate is in production. To optimize WAN link use and improve redundancy, you enable and configure SD-WAN.
What must you do as part of this configuration update process?

• A.Replace references to interfaces used as SD-WAN members in the routing configuration.
• B.Disable the interface that you want to use as an SD-WAN member.
• C.Replace references to interfaces used as SD-WAN members in the firewall policies.
• D.Purchase and install the SD-WAN license, and reboot the FortiGate device.

Refer to the exhibit. Which action will FortiGate take if it detects SD-WAN members as dead?

• A.FortiGate brings down port5 after it detects all SD-WAN members as dead.
• B.FoftiGate bounces port5 after it detects all SD-WAN members as dead.
• C.FortiGate fails over to the secondary device after it detects port5 as dead.
• D.FortiGate sends alert messages through poft5 when it detects all SD-WAN members as dead.

SD-WAN interacts with many other FortiGate features. Some of them are required to allow SD- WAN to steer the traffic.
Which three configuration elements that you must configure before FortiGate can steer traffic according to SD-WAN rules? (Choose three.)

• A.Firewall policies
• B.Security profiles
• C.Routing
• D.Traffic shaping
• E.Interfaces

Refer to the exhibits. The interface details, static route configuration, and firewall policies on the managed FortiGate device are shown.
You want to configure a new SD-WAN zone, named Underlay, that contains the interfaces port1 and port2.
What must be your first action?

• A.Delete the static routes.
• B.Delete the firewall policies.
• C.Define port1 as an SD-WAN member.
• D.Delete the SD-WAN Zone Test.