Online Access Free NSE5_FSW_AD-7.6 Exam Questions

Exhibit.

Two routes are not installed in the forwarding information base (FIB) as shown in the exnibit. Which two statements about these two route entries are true? (Choose two.)

• A.These two routes have a higher administrative distance value available to the destination networks.
• B.These two routes will become primary, if the best routes are removed.
• C.These two routes will be used as load-balancing routes.
• D.These two routes are available in the hardware routing table.

Refer to the exhibit.

You just connected three FortiSwitch devices:Core-1,Core-2, andAccess-1. Core-1 and Core-2 both connect to Access-1 for redundancy. All switches are managed by FortiGate, which uses port4 as the FortiLink interface. After you enable the uplink ports on Core-2, you notice that port3 on Access-1 enters the Discarding STP state. What is the most likely cause of this behavior? (Choose one answer)

• A.Bridge Protocol Data Unit (BPDU) Guard is enabled, which shuts down the port after it receives BPDUs.
• B.FortiGate is not running Spanning Tree Protocol (STP) on the FortiLink interface.
• C.Core-2 has the lowest bridge priority.
• D.Access-1 is not authorized by FortiGate.

Which interfaces on FortiSwitch send out FortiLink discovery frames by default in order to detect a FortiGate with an enabled FortiLink interface?

• A.No ports are enabled by default for auto-discovery. This must be configured under config switch interface.
• B.The ports with auto-discovery enabled by default are dependent upon the FortiSwitch model.
• C.The last four switch ports on FortiSwitch have auto-discovery enabled by default.
• D.All ports have auto-discovery enabled by default.

What can an administrator do to maintain a FortiGate-compatible FortiSwitch configuration when changing the management mode from standalone to FortiLinK?

• A.Use a migration tool based on Python script to convert the configuration.
• B.Enable the FortiLink setting on FortiSwitch before the authorization process.
• C.FortiGate automatically saves the existing FortiSwitch configuration during the FortiLink management process.
• D.Register FortiSwitch to FortiSwitch Cloud to save a copy before managing with FortiGate.

Refer to the exhibit.

and an OSPF route with destination 0.0.0.0/0 [110/10]. The OSPF route is marked with a checkmark in the FIB column, while the Static route has a dash.] The routing monitor displays multiple route entries, but only some are installed in the forwarding information base (FIB). After analyzing the two route entries with the destination 0.0.0.0/0, which statement correctly describe why one of these routes is not installed in the FIB? (Choose one answer)

• A.The OSPF route has a higher metric, making it less preferred than the static route.
• B.The OSPF route with a lower administrative distance is preferred over the static route.
• C.The interface V100 for the OSPF route is down, preventing its installation.
• D.The two routes have identical destination prefixes, causing a conflict where only one is selected.