Online Access Free NSE6_FML-6.2 Exam Questions

Which of the following statements are true regarding FortiMail's behavior when using the built-in MTA to process email in transparent mode? (Choose two.)

• A.FortiMail ignores the destination set by the sender and uses its own MX record lookup to deliver email
• B.MUAs need to be configured to connect to the built-in MTA to send email
• C.FortiMail can queue undeliverable messages and generate DSNs
• D.If you disable the built-in MTA, FortiMail will use its transparent proxies to deliver email

Examine the FortiMail user webmail interface shown in the exhibit; then answer the question below.

Which one of the following statements is true regarding this server mode FortiMail's configuration?

• A.The protected domain-level service settings have been modified to allow access to the domain address book
• B.This user's account has a customized access profile applied that allows access to the personal address book
• C.The administrator has configured an inbound recipient policy with a customized resource profile
• D.The administrator has not made any changes to the default address book access privileges

Refer to the exhibit.

Which two statements about the access receive rule are true? (Choose two.)

• A.Email must originate from an example.com email address to match this rule
• B.Senders must be authenticated to match this rule
• C.Email matching this rule will be relayed
• D.Email from any host in the 10.0.1.0/24 subnet can match this rule

Refer to the exhibit.

It is recommended that you configure which three access receive settings to allow outbound email from the example.com domain on FML-1? (Choose three.)

• A.The Recipient pattern should be set to 10.29.1.45/24
• B.The Action should be set to Relay
• C.The Enable check box should be cleared
• D.The Sender IP/netmask should be set to 10.29.1.45/32
• E.The Sender pattern should be set to *@example.com

Which firmware upgrade method for an active-passive HA cluster ensures service outage is minimal, and there are no unnecessary failovers?

• A.Upgrade both units at the same time
• B.Upgrade the active unit, which will upgrade the standby unit automatically
• C.Upgrade the standby unit, and then upgrade the active unit
• D.Break the cluster, upgrade the units independently, and then form the cluster