Online Access Free NSE6_FNC-7.2 Exam Questions

In which view would you find who made modifications to a Group?

• A.The Event Management view
• B.The Security Events view
• C.The Alarms view
• D.The Admin Auditing view

By default, if after a successful Layer 2 poll, more than 20 endpoints are seen connected on a single switch port simultaneously, what happens to the port?

• A.The port is disabled
• B.The port is switched into the Dead-End VLAN
• C.The port becomes a threshold uplink
• D.The port is added to the Forced Registration group

When configuring isolation networks in the configuration wizard, why does a Layer 3 network type allow for more than one DHCP scope for each isolation network type?

• A.Any scopes beyond the first scope are used if the Initial scope runs out of IP addresses.
• B.The Layer 3 network type allows for one scope for each possible host status.
• C.There can be more than one isolation network of each type.
• D.Configuring more than one DHCP scope allows for DHCP server redundancy.

View the command and output.

What is the state of database replication?

• A.Secondary to primary synchronization failed.
• B.Primary to secondary database synchronization was successful.
• C.Secondary to primary synchronization was successful.
• D.Primary to secondary synchronization failed.

Where do you look to determine when and why the FortiNAC made an automated network access change?

• A.The Port Changes view
• B.The Connections view
• C.The Admin Auditing view
• D.The Event view