Online Access Free NSE7_SDW-6.4 Exam Questions

What are two reasons for using FortiManager to organize and manage the network for a group of FortiGate devices? (Choose two )

• A.It simplifies the deployment and administration of SD-WAN on managed FortiGate devices.
• B.It improves SD-WAN performance on the managed FortiGate devices.
• C.It acts as a policy compliance entity to review all managed FortiGate devices.
• D.It reduces WAN usage on FortiGate devices by acting as a local FortiGuard server.
• E.It sends probe signals as health checks to the beacon servers on behalf of FortiGate.

Refer to the exhibit.

Which are two expected behaviors of the traffic that matches the traffic shaper? (Choose two.)

• A.The traffic shaper limits the bandwidth of each source IP address to a maximum of 625 KB/sec.
• B.The number of simultaneous connections among all source IP addresses can exceed 5 connections.
• C.The number of simultaneous connections allowed for each source IP address can exceed 5 connections.
• D.The traffic shaper limits the combined bandwidth of all connections to a maximum of 5 MB/sec.

What is the purpose of a predefined template on the FortiAnalyzer?

• A.It contains predefined data to generate mock reports
• B.It can be edited and modified as required
• C.It specifies report settings which contains time period, device selection, and schedule
• D.It specifies the report layout which contains predefined texts, charts, and macros

What are the two minimum configuration requirements for an outgoing interface to be selected once the SD-WAN logical interface is enabled? (Choose two )

• A.Specify outgoing interface routing cost.
• B.Configure SD-WAN rules interface preference.
• C.Specify incoming interfaces in SD-WAN rules.
• D.Select SD-WAN balancing strategy.

Refer to the exhibit.

Which conclusion about the packet debug flow output is correct?

• A.The original traffic exceeded the maximum packets per second of the outgoing interface, and the packet was dropped.
• B.The original traffic exceeded the maximum bandwidth configured in the traffic shaper, and the packet was dropped.
• C.The reply traffic exceeded the maximum bandwidth configured in the traffic shaper, and the packet was dropped.
• D.The original traffic exceeded the maximum bandwidth of the outgoing interface, and the packet was dropped.