Online Access Free NSE7_SDW-7.2 Exam Questions

The administrator uses the FortiManager SD-WAN overlay template to prepare an SD-WAN deployment.
With information provided through the SD-WAN overlay template wizard, FortiManager creates templates ready to install on spoke and hub devices.
Select three templates created by the SD-WAN overlay template for a spoke device. (Choose three.)

• A.System template
• B.BGP template
• C.IPsec tunnel template
• D.CLI template
• E.Overlay template

Refer to the exhibits.
Exhibit A -

Exhibit B -

Exhibit A shows a site-to-site topology between two FortiGate devices: branch1_fgt and dc1_fgt. Exhibit B shows the system global and system settings configuration on dc1_fgt.
When branch1_client establishes a connection to dc1_host, the administrator observes that, on dc1_fgt, the reply traffic is routed over T_INET_0_0, even though T_INET_1_0 is the preferred member in the matching SD-WAN rule.
Based on the information shown in the exhibits, what configuration change must be made on dc1_fgt so dc1_fgt routes the reply traffic over T_INET_1_0?

• A.Enable auxiliary-session under config system settings.
• B.Disable allow-subnet-overlap under config system settings.
• C.Disable t#p-session-without-syn under config system settings.
• D.Enable snat-route-change under config system global.

What is a benefit of using application steering in SD-WAN?

• A.You do not need to configure firewall policies that accept the SD-WAN traffic.
• B.The traffic always skips the regular policy routes.
• C.You steer traffic based on the detected application.
• D.You do not need to enable SSL inspection.

Within IPsec tunnel templates available on FortiManager. which template will you use to configure static tunnels for a hub and spoke topology?

• A.Static_IPsec_Recommended
• B.Branch_IPsec_Recommended
• C.Hub_IPsec_Recommended
• D.IPsec_Fortinet_Recommended

The SD-WAN overlay template helps to prepare SD-WAN deployments. To complete the tasks performed by the SD-WAN overlay template, the administrator must perform some post-run tasks. What are three mandatory post-run tasks that must be performed? (Choose three.)

• A.Configure SD-WAN rules.
• B.Configure routing through overlay tunnels created by the SD-WAN overlay template.
• C.Assign an sdwan_id metadata variable to each device (branch and hub).
• D.Create policy packages for branch devices.
• E.Assign a branch_id metadata variable to each branch device.