Online Access Free NSE8_812 Exam Questions

On a FortiGate Configured in Transparent mode, which configuration option allows you to control Multicast traffic passing through the?

• A.Option C
• B.Option D
• C.Option B
• D.Option A

Refer to the exhibits.
Exhibit A

Exhibit B

Exhibit C

A customer is trying to set up a VPN with a FortiGate, but they do not have a backup of the configuration.
Output during a troubleshooting session is shown in the exhibits A and B and a baseline VPN configuration is shown in Exhibit C Referring to the exhibits, which configuration will restore VPN connectivity?

• A.
• B.
• C.
• D.

You deployed a fully loaded FG-7121F in the data center and enabled sslvpn-load-balance. Based on the behavior of this feature which statement is correct?

• A.You can use src-ip or dst-ip-dport on dp-load-distribution-method to make SSL VPN load balancing work as expected.
• B.If an FPM goes down, SSL VPN IP pool IP addresses will be re-allocated to the remaining FPMs.
• C.To have better traffic distribution you should use IP pools that increment in multiples of 12.
• D.Enabling SSL VPN load balancing will clear the session table.

Refer to the exhibit showing the history logs from a FortiMail device.

Which FortiMail email security feature can an administrator enable to treat these emails as spam?

• A.Impersonation analysis in an antispam profile
• B.DKIM validation in a session profile
• C.Soft fail SPF validation in an antispam profile
• D.Sender domain validation in a session profile

Refer to the exhibit.

You are deploying a FortiGate 6000F. The device should be directly connected to a switch. In the future, a new hardware module providing higher speed will be installed in the switch, and the connection to the FortiGate must be moved to this higher-speed port.
You must ensure that the initial FortiGate interface connected to the switch does not affect any other port when the new module is installed and the new port speed is defined.
How should the initial connection be made?

• A.Connect the switch on any interface between ports 5 to 8.
• B.Connect the switch on any interface between ports 1 to 4
• C.Connect the switch on any interface between ports 21 to 24
• D.Connect the switch on any interface between ports 25 to 28