After executing the display interface Ethernet 1/0/1 command on the switch SWA, the output information is as follows

It can be judged from the above output that _____.

The two routers are connected through the LAN to form a VRRP backup group. The VRRP timer configuration on each interface is as follows:
[RTA-GigabitEthernet1/0]vrrp vrid 1 timer advertise 5
[RTB-GigabitEthernet1/0]vrrp vrid 1 timer advertise 5
VRRP backup group 1 is operating normally, RTA is the Master and RTB is the Backup. If the router RTA fails after the device runs for a period of time, the time for the router RTB to change from Backup to Master may be

The following statement about the three-layer switch is correct.

Regarding RP and BSR, which of the following statements are correct?

In the switching network as shown in the figure, VLAN10 is set as Super VLAN on switch SWA, VLAN2 and VLAN3 are Sub VLAN of VLAN10, port Ethernet1/0/3 is Trunk port, PVID is VLAN1, allowing all VLANs to pass through; Create VLAN2~VLAN20 on SWB, port Ethernet1/0/4 as Trunk port, PVID is VLAN1, allowing all VLANs to view Ethernet 1/0/3 port information on SWA, the correct one is displayed below