Online Access Free HP0-Y37 Exam Questions

Click the Exhibit button and view the three exhibits.



After you issue the command irf-port-configuration active on HP A5800 Switch members 4 and 5, the 10 Gigabit Ethernet link 1/0/25 is connected. What is the expected result? (Select two.)

• A.Only IRF Member 5 reboots.
• B.IRF Member 5 becomes the Master.
• C.IRF Member 3 becomes the Master.
• D.IRF Member 2 becomes the Master.
• E.IRF Members 2 and 4 reboot.
• F.IRF Members 3 and 5 reboot.
• G.Only IRF Member 4 reboots.

You intend to install HP switches on an existing Cisco network. To prepare the progressive replacement of Cisco edge switches with HP switches, you want to implement LLDP on the current Cisco network. The Cisco distribution switches support LLDP. However, the Cisco edge switches are of different models running various IOS and may not support LLDP. Some IP phones may only use CDP. What should you do?

• A.Run CDP and LLDP in parallel on distribution and edge switches where allowed.
• B.Run CDP on Cisco switches and LLDP on HP switches (HP switches convert CDP BDPUs to LLDP BDPUs).
• C.Choose between CDP and LLDP.
• D.Enable CDP on HP switches.

In RRPP Ring 3 of an HP A-Series switch, the RRPP port status of the primary port is UP, but the port status of the secondary port is BLOCKED. What most likely caused this?

• A.The state of Ring 3 is fail.
• B.Spanning Tree is enabled on the secondary port.
• C.The state of Ring 3 is complete.
• D.The switch is misconfigured.
• E.The state of Ring 3 is incomplete.
• F.There is no Master in Ring 3.

Click the Exhibit button and view a network diagram and two switch configurations.

What is the node mode of Switch 3 in RRPP Ring 3?

• A.Slave
• B.Edge
• C.Transit
• D.Master
• E.Primary
• F.Assistant Edge

Which statements are true about DHCP Snooping? (Select two.)

• A.DHCP Snooping is a Cisco Proprietary protocol. The standard is not yet ratified.
• B.The DHCP Snooping binding table contains information about hosts interconnected with a trusted interface.
• C.DHCP Snooping is when a switch acts as a DHCP server for end nodes that connect to that particular switch. This way, end nodes always get an IP address.
• D.DHCP Snooping prevents end nodes from receiving IP address assignments from an unauthorized DHCP server.
• E.DHCP Snooping is a malicious attack against the DHCP servers.
• F.When configuring DHCP Snooping on a switch, you define which ports are trusted to receive DHCP offers. Typically uplinks of a switch are trusted and Edge ports are untrusted.