Online Access Free HP2-T23 Exam Questions

A support engineer is troubleshooting a ProLiant DL360p Gen8 server.A hard disk m a four drive RAID 5 set has failed.The engineer notices that on three of the drives, the LEO labeled D on the exhibit is on.What does the condition indicate?

• A.The drives should not be removed when this LED is illuminated
• B.Hot swapping of the failed drive is not supported in this condition
• C.The drive failure has corrupted three drives in the RAID set. The array must be rebuilt and data restored from backup
• D.The LED indicates failure and predictive failure alerts. Two additional drives in the RAID set are at risk of failing and need to be replaced

What should you do if an online firmware flash of the system board fails?

• A.Replace the system board because the flash is corrupt.
• B.Retry the flash before rebooting the server.
• C.Download a new version of the ROM, reboot the server and try again.
• D.Reboot the server, remove power, and try again.

A support engineer is installing DIMMs of different speeds and voltages in a ProLiant DL380p Gen8 Server. Which rules for DIMM installation must the engineer follow during this installation?

• A.UDIMMs, RDIMMs, and LRDIMMs may be mixed in the same bank in the server if only one processor is installed.
• B.Four quad-ranked LRDIMMs are supported across all memory channels. The server balances capacity automatically.
• C.RDIMMs operating at either 1.35V or 1.5V may be mixed in any order. The system will operate at the lower voltage.
• D.DIMMs of different speeds may be mixed in any order. The server will select the lowest common speed.

For which purpose is HP Power Protector used?

• A.Power capping of a c7000 enclosure
• B.Preventing the overload of a power supply unit in a c7000 enclosure
• C.Web-based management of the UPS
• D.Making a backup of the system disk

You are viewing the current driver and firmware status in the Version Control Agent (VCA) and notice that only one column of information is presented.
What must you do to see the current status and the latest revision available?

• A.Upgrade the System Management Homepage (SMH) VCA to the latest version to reflect the changes needed to access the new revisions.
• B.Set up the central management server (CMS) to check for the latest Service Pack for ProLiant (SPP) and push it to the VCA.
• C.Configure the VCA to use the Version Control Repository Manager (VCRM).
• D.Reboot the server to use the new VCA version, because the server has recently installed updates.