Online Access Free HP2-T25 Exam Questions

A support engineer needs to replace drives on a ProLiant Gen8 server and must securely erase customer data. How can this be achieved?

• A.Run the HP System Erase Utility to reset all disks.
• B.Run a third-party disk shredding tool.
• C.Run the HP System Erase Utility to reset RBSU.
• D.Run the HP System Erase Utility to reset all settings.

A ProLiant DL380 Gen8 server has had the system hang over the last two weeks. You contacted HP Technical Support and were asked to send them the Active Health System log for the last two weeks.
Where can you download this log? (Select two.)

• A.Array Configuration Utility (ACU)
• B.Integrated Management log (IML)
• C.iLO information page
• D.Intelligent Provisioning Maintenance page
• E.ROM Based Setup Utility (RBSU)

Which RAID level allows the data to be striped across multiple RAIDs? (Select two.)

• A.RAID 60
• B.RAID 0
• C.RAID 1
• D.RAID 5
• E.RAID 50

The ILO of an HP Integrity rx2800 i2 server does not respond through LAN or serial connection nut the operating system is up and can be accessed.How can you reset the ILO?

• A.Press and hold the power button at the front of the server for four to eight second
• B.As there is no ILO reset button shut down the operating system of the server and the power cycle it with the power button at the front of the server
• C.As there is no ILO reset button reboot the operating system of the server
• D.Press the ILO physical presence pinhole button at the rear of the server for less than four second

You need to replace one of the processors in a dual processor ProLiant Server. Which processor should become the primary processor?

• A.the processor with the lowest stepping
• B.the new processor
• C.the server will choose it automatically on next power-on.
• D.the processor with the highest stepping