Online Access Free HP2-Z26 Exam Questions

A network administrator has installed IMC and the appropriate licenses. The network administrator is attempting to import the HP Comware and HP Provision switches into IMC but is experiencing problems importing the Comware switches. The network administrator verifies the SNMPv2c configuration on both sets of switches and the SNMP configuration in IMC. The SNMP parameters are correct.
What is the cause of the import problem?

• A.Comware switches are not fully supported by IMC.
• B.Comware switches require SSH to be configured for remote CLI access.
• C.Comware switches do not have telnet fully configured.
• D.Comware switches implement SNMPv3 by default.

Based on the default precedence used to rank routing protocols in HP Comware switches, if a default route (0.0.0.0/0) is learned from multiple routing protocols, which source would the Comware operating system prefer?

• A.Static
• B.RIP
• C.External BGP
• D.Internal OSPF

A network administrator enables debug to troubleshoot an OSPF adjacency on an HP Comware switch. The network administrator then disables and then re-enables an interface connected to another switch running OSPF. After waiting for a few minutes, no output displays on the console.
Which action must the network administrator take to resolve this problem?

• A.Restart the OSPF process.
• B.Execute the terminal debugging command.
• C.Execute the terminal logging command
• D.Re-initialize OSPF on the respective interface.

A network administrator executes the following command:

What is the state of the VLAN 1 interface?

• A.All interfaces in VLAN 1 are down.
• B.The IP address for VLAN 1 is a duplicate of another VLAN interface on the switch.
• C.VLAN 1 has a single port in a down state.
• D.The IP address of VLAN 1 conflicts with another device in VLAN 1.

Refer to the network exhibit.

A network administrator has a server with a single link to the network The company is concerned about redundancy and wants to implement a solution like that shown in the right-hand side of the diagram. Which solution meets the company's needs?

• A.HP Comware switches using distributed trunking or IRF
• B.HP Comware switches using IRF only
• C.HP Comware or HP Provision switches using IRF
• D.HP Comware switches using meshed IRF or meshed stacking
• E.HP Comware switches using distributed trunking only