Online Access Free HP2-Z30 Exam Questions

Which HP Provision switch command controls the logging level of messages sent to a syslog server?

• A.logging severity
• B.info-center level
• C.syslog severity
• D.logging-host trap-level

Which Layer 2 mechanism should be used to authenticate wireless or wired users before allowing them access to network resources?

• A.802.1Z
• B.WPA
• C.802.1X
• D.MIMO

Which statement is true concerning PoE support on HP ProVision and HP Comware switches?

• A.PoE is enabled by default on PoE-capable ports.
• B.Lowered-number ports, by default, have higher priority for Power requests.
• C.SNMP is used to determine power requirements of a connected devices.
• D.Both the IEEE 802.3af and 802.3az power standards are supported.

Refer to the network exhibit.

All of the switches in the exhibit are configured as follows:
Config name = "Region!'
Revision #= 1
Instance 1=VLANs 10.12
lnstance2 = VLANs11,13
1ST instance = VLANs 1-9.14-4094
Currently, onlyVLANs 1,10,11,12, and 13 exist on the four switches. A network administrator adds VLAN 15 to Switch_C. How is the topology affected by this change?

• A.No topology changes occur with spanning tree.
• B.Spanning tree recalculates, with load sharing not in effect to Switch_C.
• C.Spanning tree recalculates, with load sharing still in effect to Switch_C.
• D.A loop now exits involving Switch_

Which statement is true about using the RADIUS protocol for AAA functions'?

• A.AAA accounting records can be saved using RADIUS or syslog.
• B.Only passwords are encrypted in the RADIUS payload.
• C.RADIUS uses TCP as a transport.
• D.Digital certificates are used to authenticate the networking devices and AAA server.