Online Access Free HP2-Z34 Exam Questions

Multiple data centers connect over an HP EVI network. IPv4 servers in the data centers use Microsoft network load-balancing and need to send multicasts to each other across EVI links.
They do not use IGMP to join the multicast groups. What must the administrator do?

• A.Enable IGMP proxy on the EVI tunnel interfaces. l^
• B.Enable Multicast Learner Discovery (MLD) on the EVI tunnel interfaces.
• C.Enable Protocol Independent Multicasting (PIM) on the EVI tunnel interfaces.
• D.Configure selective flooding for the multicast group addresses on the EVI tunnel interfaces

Refer to the exhibit

An administrator is setting up this data center topology to use SPBM VMs in the same subnet should be able to communicate at Layer 2 and be isolated at Layer 2 from other subnets. On which Switch 1 interfaces should the administrator enable SPBM?

• A.VLAN interfaces 10, 20, and 30
• B.VLAN interfaces 101 and 103
• C.interfaces Forty 1/0749-1/075E only
• D.interfaces Ten1/0/1-Ten1/0/48 and interfaces Forty1/0749-1/0750

Refer to the exhibit

An administrator is establishing an MPLS domain to allow communication between 10.1.0.0/16.10 2 0 0/16. and 10.3 0.0/16. The solution will use OSPF routing and LDP. On which PE and P devices should these protocols be configured?

• A.All P and PE devices should be configured with MPLS, but only PE devices need OSPF and LDP.
• B.All P and PE devices should be configured with MPLS, butonly P devices need OSPFand only PE devices need LDP.
• C.All P and PE devices should be configured with MPLS and LDP. but only PE devices need OSPF.
• D.All P and PE devices should be configured with MPLS, LDP. and OSPF.

Refer to the exhibit

An administrator is configuring an MPLS VPLS Martini solution on PE-1. The VPLS solution should connect customer A sites 1, 2, and 3 Where should the administrator specify the LDP peers and pseudo wire (PW) label for the PWs?

• A.in service instances on interfaces Ten2/0/1 and Ten2/0/2
• B.in a Virtual Switch Instance (VSI) for customer A
• C.in a service instance on interface G1/0/1
• D.in a global cross-connect group

An administrator is implementing MDC and wants to create a redundant solution where each MDC uses two physical HP Comware switches.What is the correct setup process?

• A.Combine the two switches in an Intelligent Resilient Framework (IRF) virtual device Set up the MDCs on this device.
• B.Set up the MDCs on both switches. Use the Admin MDC to configure Intelligent Resilient Framework (IRF) on the two switches
• C.Set up the MDCs on both switches. Configure Intelligent Resilient Framework (IRF) between the two switches on each MDC separately.
• D.Enable MDC on both switches in resiliency mode Configure the MDCs on each device using the same MDC IDs on each Connect the devices.