Online Access Free HPE0-J50 Exam Questions

A storage integrator is installing the HPE StoreVirtual Centralized Management Console (CMC) to manage a StoreVirtual VSA cluster.
What is the proper procedure to install the console?

• A.Download the StoreVirtual CMC installer and run on the computer with a supported Linux operating system.
• B.Download the StoreVirtual CMC installer and start the installation from primary StoreVirtual VSA node.
• C.Download the CMC Appliance and deploy to a hypervisor not running StoreVirtual VSA nodes.
• D.Download the CMC Appliance and deploy to hypervisors running StoreVirtual VSA nodes.

Click on an available port that can be used to connect an HPE 3PAR StoreServ 8000 to drive enclosures.
(Click on the correct port.)

Correct Answer:

Explanation

References:

An HPE StoreVirtual 3200 system consists of 19x 1.2 TB Drives in a RAID5 with a capacity level of 75%.
The network is built with four HPE FlexFabric 5900 switches.
The customer complained about performance challenges with the given configuration, and the administrator identified the drive configuration as a bottleneck. A performance analysis shows latencies above 60ms.
Installation of the systems was done by best practices.
Which actions should be performed to solve these issues? (Choose two.)

• A.Advise additional tiering licenses.
• B.Verify that a minimum of 4 RAID sets are built for optimal performance.
• C.Offer SSD drives for tiering purposes and a performance boost.
• D.Change RAID set to RAID 1 on both systems.
• E.Set the bonding policy to ALB on both systems.

A customer currently utilizing HPE 3PAR StoreServ 7200 is experiencing performance bottlenecks within their SAN storage.
Which cost-effective upsell or cross-sell HPE storage solution will offer significantly more performance and higher capacity to meet their needs and fit within their current infrastructure?

• A.HPE 3PAR StoreServ 8440
• B.HPE 3PAR StoreServ File Controller v3 System
• C.HPE StoreVirtual 3200 Storage
• D.8-node HPE 3PAR StoreServ 20000 Storage

A storage integrator is planning an HPE MSA Storage installation.
What needs to be taken into consideration when implementing a SAS connected model?

• A.Up to four servers with non-redundant paths can be connected.
• B.Up to four servers with redundant paths can be connected.
• C.SAS expander or a SAS switch is required if eight or more servers are connected.
• D.SAS expander or a SAS switch is supported only with non-redundant paths.