Online Access Free HPE0-S50 Exam Questions

A customer reports that performance is not adequate for an application using a hybrid HPE StoreVirtual VSA.
How can a Synergy integrator improve performance for this application?

• A.Change the volume for the application on the VSA to thin provisioned.
• B.Change the volume for the application on the VSA to thick provisioned.
• C.Migrate the volume from Network RAID10 to Network RAID50.
• D.Enable adaptive optimization on the volume for the application.

A customer is planning an HPE Synergy solution with 20 frames an needs to minimize the number of management ports that are required to connect the frames into the existing management network.
Which procedure should the Synergy into a integrator use to address the customer's concern?

• A.Connect FLMs from all frames to two external switches for redundancy: Then connect the two uplinks from the two switches into the customer management network.
• B.Connect the RJ-45 front port of each frame to two external switches for redundancy: Then connect the uplink from the two switches into the customer's management network.
• C.Connect FLMs from all frames into a management ring: Then connect the management ring to the customer's management network using two uplinks.
• D.Connect the RJ-45 front ports of each frame to an external switch. Then connect the uplink from the external switch into the customer management network.

A customer has HPE SY 480 modules with two CPUs and 384GB (16GB DIMMS) of memory. The customer needs to double the CPU and memory capacity for java application server.
What should a Synergy integrator do to meet the customer needs?

• A.Install an HPE Synergy SY 680 compute module and reassign the server profile .
• B.Install an HPE Synergy SY 620 compute module and reassign the server profile.
• C.Upgrade the HPE Synergy SY 480 to two additional CPUs and replace 16GB dimms with 64Gb.
• D.Upgrade the HPE Synergy SY to two additional CPUs and replicate 16 Gb dimms with 32Gb.

Refer to the exhibit

A customer with the configuration shown attempts to configure a server profile for a now application that requires 20Gb of bandwidth, but the configuration fails. The HPE SV 480 Gen9 compute modules have two Intel Xeon E5 - 2695 v4 processors. 256GB of RAM and HPE Synergy 352QC Converged Network Adapters installed.

• A.Converged Network Adapter is unable to support 20Gb
• B.HPE Virtual Connect SE 40GBb Module does not support 20 Gb.
• C.HPE 10 Gb interconnect Link Module does not support 20Gb
• D.Intel processor does not have enough PCI-e lanes for 20 Gb.

Refer to the exhibit.

How should a Synergy integrator pair interconnect bays to set up redundant fabrics in an HPE Synergy 12000 Frame?

• A.Interconnect bays 1 and 1 and 6: bays 2 and 5: bays 3 and 4.
• B.Interconnect 1 bays 1 and 4: bays 2 and 5: bays 3 and 6.
• C.Interconnect bays 1 and 3: bays 2 and 4: bays 5 and 6.
• D.Interconnect bays 1 and bays 2: bays 3 and 4: bays 5 and 6.