Online Access Free HPE0-S58 Exam Questions

A customer tries to revert a data volume located on the HPE 3PAR array to a specific snapshot that was taken using HPE Composer, but the process fails.
What must an integrator do to fix this problem?

• A.Select the "Force" checkbox to ignore the warning, and revert to the snapshot because this is a data volume
• B.Navigate to the SSMC and revert to the snapshot using HPE 3PAR tools
• C.Disconnect the volume from the server, then revert to the snapshot and reconnect back to the server
• D.Install the snapshot agent on the operating system to enable online snapshot operations

During a first-time installation of HPE Synergy, an external monitor is not available to the integrator.
Which approach should the integrator take to perform the first-time setup?

• A.Download PuTTY, connect the laptop to the front Panel Ethernet port, and open an SSH connection to 192.168.10.1 on any port (default is 22).
• B.Download MSTCS, connect the laptop to the front Panel Ethernet port, and open a RDP Session to 192.168.10.1 on port 443.
• C.Download Telnet, connect the laptop to the front Panel Ethernet port, and open a connection to 192.168.10.1 on port 8443.
• D.Download VNC Viewer, connect the laptop to the front Panel Ethernet port, and open a VNC-connection to 192.168.10.1 on port 5900.

A customer wants to boot Synergy compute nodes from external LUN located on HPE MSA 2050 SAN Storage.
What should an integrator consider when implementing this configuration?

• A.MSA2050 must be imported first to the HPE Composer before volume presentation can be done
• B.Automated zoning functionality cannot be used, as MSA2050 is not supported in HPE Composer
• C.Additional integration license must be purchased for the MSA2050 and Synergy platforms
• D.Using HPE Composer, only volumes up to 4TB can be created on the MSA2050

Refer to the exhibit.

A Synergy integrator needs to establish the module cluster links between two master modules, as shown.
Which ports can the integrator use for the module cluster links?

• A.3 and 4
• B.5 and 6
• C.1 and 2
• D.7 and 8

An integrator needs to configure a set of networks for Synergy compute nodes to send data to devices outside of a Synergy frame.
How should the integrator complete the task?

• A.Add the network to an interconnect bay within a Logical Enclosure (LE)
• B.Add the networks to an Enclosure Group (EG)
• C.Add the network sets to a Logical Interconnect Group (LIG)
• D.Add the networks to an uplink set within a Logical Interconnect Group (LIG)