A.M-LAG has to be defined manually for HPE BladeSystem, but it is automatically configured for HPE Synergy.

B.When combined with IRF, M-LAG will allow you to aggregate ports coming from clustered HPE Synergy Virtual Connect modules.

C.sFLOW cannot be enabled if M-LAG is configured between HPE Synergy Virtual Connect modules in the same frame.

D.M-LAG for HPE Synergy can be either single-homed or multi-homed, while for HPE BladeSystem only single-homed.

A.The server does not have an HPE OneView license applied

B.The server is powered on

C.The server is powered off

D.You tried to add additional connection above the limit

A.Baseboard Management Controller (BMC)

B.Rack Management Controller (RMC)

C.all nPARs created within the complex

D.only the base chassis from the complex

A.Remote frame Link Module IPv6 address

B.Request code from the primary HPE Composer

C.UUD of the remote HPE Composer

D.Serial number of one of the remote frames