Online Access Free HPE2-Z38 Exam Questions

A college is implementing HP Network Protector SDN Application to mitigate network attacks.
To conserve bandwidth, the college wants to prevent students from accessing social media web sites while the students are connected to the college network. However, the college wants to give professors more flexibility, while still protecting the network.
Which configuration meets these requirements?

• A.Place all professors in one VLAN and exclude that VLAN from the flows defined for HP Network Protector SDN Application.
• B.Create different groups for students and professors, and define a customized blacklist for the student group.
• C.Create a customized greylistfor professors.
• D.Add the professors as exceptions to the college's blacklist.

A DHCP response from a device with IP address 10.10 10. 10 arrives on the switch with the OpenFlow flow table entries shown in the exhibit. Based on this exhibit, Based on this exhibit, what is the correct behavior of the controller in this scenario?

• A.forwards it using normal switching and sends it to the controller
• B.sends it on the port with ID 200
• C.forwards it using normal switching but does not send it to the controller
• D.drops it

What can network administrators use to configure backup and restore options for an HP
VAN SDN Controller?

• A.Controller GUI
• B.intent
• C.REST
• D.SNMP

The network administrator is setting up a controller team.
The team address is 192.168.100.100, and the three controllers are using 192.168.100.110, 192.168.100.111 and 192.168.100.112.
The administrator is configuring a switch with only basic IP connectivity that can reach the controller team.
The administrator starts to configure a new OpenFlow instance by using the commands shown in the exhibit.
The instance fails to activate.
How should the administrator change the configuration to enable it to activate?

• A.Move to the appropriate VLAN context and add the OpenFlow instance.
• B.Add one or more VLANs to the OpenFlow instance.
• C.Change the default setting for controller mode from single to team.
• D.Change the IP address for all controllers to the team address.

What does this exhibit indicate?

• A.The controller and switch did negotiate the OpenFlow version but could not program the flows yet.
• B.The controller and switch do not support hybrid OpenFlow mode.
• C.The controller and switch have not yet negotiated the OpenFlow version.
• D.The controller and switch have negotiated the OpenFlow version as 1.0.