Online Access Free HPE6-A41 Exam Questions

Refer to the exhibit.

The student A client needs to connect to FTP Server B.
Student A sends the necessary ARP request and receives a reply.
Which destination MAC address does the Student A client use in the FTP packet to FTP Server B?

• A.00-1D-B3-F1-EF-31
• B.00-E0-52-F0-44-87
• C.00-E0-52-F0-41-B2
• D.00-1D-B3-F1-EF-40

Member 1 is the commander of a Virtual Switching Framework (VSF) fabric. A power disruption causes member1 to go down. What happens when power is restored and member 1 boots?

• A.Member 1 rejoins the VSF fabric, and member 2 continues to act as commander.
• B.Member 1 fails to rejoin the VSF fabric, and member 2 continues to act as commander.
• C.Member 1 fails to rejoin the VSF fabric, and the error disrupts member 2.
• D.Member 1 rejoins the VSF fabric and becomes the commander.

Refer to the exhibit.

A network administrator wants to set up a link aggregation between two switches, as shown in the exhibit. The link aggregation must meet these requirements:
* Protects against misconfiguration
* Can be configured with VLANs and other settings
Which type of link aggregation should the administrator create?

• A.dynamic LACP
• B.manual (trunk)
• C.static LACP
• D.distributed (trunk)

A company has an Aruba 5400R switch, switch 1, at the network core of its campus. This switch routes all traffic for the campus and is the RSTP root. The company now wants to add another Aruba 5400R switch to the core in order to enhance resiliency. The company wants to use the option that provides the best Layer 2 and Layer 3 resiliency and also the simplest setup.
What should the administrator do to add the new 5400R switch?

• A.Add the new switch and migrate to MSTP with two instances.
• B.Add the new switch as a secondary root bridge in RSTP.
• C.Add the new switch as a standby member in a VSF fabric with switch 1.
• D.Add the new switch and set up OSPF on all switches.

A network administrator wants to deploy Aruba Instant APs (IAPs) at a remote site that does not have Internet access. The APs should receive their configuration automatically from AirWave by using Zero Touch Provisioning (ZTP). What does the administrator need to configure?

• A.the name of the AirWave VLAN with the configuration that the APs should use
• B.the name and password of a user with full administrative rights to AirWave
• C.the IP address for the DNS server with the mapping for the airwave hostname
• D.the DHCP server configured with options 43 and 60 for ZTP