Online Access Free HPE6-A75 Exam Questions

What are Operator Profiles used for?

• A.to map AD attributes to admin privilege levels in ClearPass Guest
• B.to enforce role based access control for ClearPass Policy Manager admin users
• C.to enforce role based access control for ClearPass Guest Admin users
• D.to enforce role based access control for Aruba Controllers
• E.to assign ClearPass roles to guest users

Refer to the exhibit.


The network administrator needs to set up BGP between the two company switches. Switch-1 and Switch-2. The BGP connection does not establish. Based on the exhibits, what does the administrator need to do to fix the issue?

• A.Enable the multihop option for the neighbor on each of the switches.
• B.Enter the network command for 10.0.0.0/24 in the router BGP mode on each switch.
• C.Enable BGP on the interfaces that the switches use to reach each other.
• D.Set the update source for the neighbor to the local loopback interface on each switch.

Refer to the exhibit. Several interfaces on an AOS-Switch enforce 802. IX to a RADIUS server at
10.254.378.521. The interface 802. IX settings are shown in the exhibit, and 802. IX is also enabled globally. The security team have added a requirement tor port security on the interfaces as well. Before administrators enable port security, which additional step must they complete to prevent issues?

• A.Manually add legitimate MAC addresses to the switch authorized MAC list.
• B.Enable DHCP snooping on VLAN 20.
• C.Enable eavesdropping protection on the interfaces.
• D.Set an 802. l X client limit on the interfaces.

An AOS-Switch uses tunneled node. What is a best practice for the path between an AOS-Switch and its Mobility Controller?

• A.The path implements MACsec
• B.The path crosses no VLAN boundaries
• C.The path has a device that applies NAT
• D.The path can support jumbo frames

An administrator supports a cluster of four Aruba Mobility Controllers (MCs) with management addresses of 10.1.100.101, 10.1.100.102, 10.1.100.103, and 10.1.202.181. The administrator accesses an AP associated with this cluster, reboots it and accesses apboot mode. The administrator executes the printenv command. Which AP parameter contains the IP addresses of the cluster members that the AP should use to connect to the cluster?

• A.Servername
• B.Noodelist
• C.Cfg_lms
• D.Master_ip