Online Access Free HPE7-A07 Exam Questions

A customer's infrastructure is set up to use both primary and secondary gateway clusters on the SSID profile based on best practices What is a valid cause tor having an equal spirt in APs connected to the primary and secondary gateway clusters?

• A.The secondary gateway cluster is heterogeneous
• B.The primary gateway cluster is up. out some APs are unable to reach the primary gateway cluster. These APs would connect to the secondary gateway cluster
• C.The primary gateway cluster is up. out some APs cannot reach the secondary gateway cluster. These APs would connect to the secondary gateway cluster
• D.The secondary gateway cluster is homogeneous

Which statement is true given the following CLIoutput from a CX 6300?

• A.There are two anycast addresses m me overlay fabric.
• B.The underlay loopback addresses are in the 172 21 11 x range.
• C.Duplicate MAC addresses were detected in the overlay fabric
• D.There are three active client overlay VLANs in the overlay fabric

A customer has deployed an AOS 10 mobility gateway cluster consisting of three controllers at a single site The WLAN is configured to tunnel wireless device traffic to the AOS 10 mobility cluster The clients are authenticated by ClearPass using WPA3-Enterprise (opmode wpa3-aes-ccm-128). The security team has requested the ability to force a wireless device to reauthenticate using ClearPass.
Which steps are required to ensure ClearPass can consistently initiate a change of authorization against an AOS 10 mobility cluster, including during gateway failover scenarios? (Select two)

• A.modify WLAN - SSID - VLAN - Mode Configuration
• B.modify NAS IPv4 address under Security - Advanced - RADIUS Client
• C.set cluster mode to Auto Site under High Availability - Cluster configuration
• D.enable Dynamic Authorization CoA under High Availability - Cluster Configuration
• E.enable manual cluster configuration under High Availability - Cluster Configuration

A customer wan a gateway connected to a device on gigabitethernet0/0/3 configures an Asset ID TLVon the device for inventory management.
Exhibit.

The customer mentions me Asset ID is not shown What is causing the issue?

• A.Unknown TLVs cannot be displayed.
• B.MTU size is too small.
• C.LLDP TX is not enabled.
• D.LLPD-MED needs to be enabled.

in a WLAN network with a tunneled SSID. you see the following events in HPE Aruba Networking Central:

The customer asks you to investigate log messages What should you tell them?

• A.This indicates a client WLAN driver issue for the client with a MAC address ending with 37:18
  :Od. You should upgrade the client WLAN driver.
• B.There is a roaming issue Enable Fast Roaming 802.11r and OKC to resolve the issue.
• C.This is normal, expected behavior. No further actions are needed.
• D.This indicates a security issue. The client with a MAC address ending with 37 18;0d Is performing a Denial-of-Service attack on your network. You should track down the client and remove it from the network.