Online Access Free Huawei.H12-261.v2022-01-21.q423 Practice Test (Page 10)

H12-261 Exam Question 41

Which of the following statements regarding MPLS is false?

A.MPLS supports multi-layer nesting. The value of the S bit of the innermost label is 1.

B.The label space range of dynamic signaling protocols such as LDP and MP-BGP from 16 to 1023.

C.When an IP packet is transmitted on an MPLS network that uses TTL processing in pipe mode, the TTL value of the IP packet decrements by 1 only at the ingress and egress nodes of the MPLS network.

D.The MPLS label is 20 bits long and is used for packet forwarding.

H12-261 Exam Question 42

The figure shows the topology and configuration. Which of the following methods can be used to exclude the specific route 10.0.3.3/32 from the routing table of R1?

A.On R2, configure a filter-policy, use the ACL applied to the filter-policy to match 10.0.3.3/32, and apply the filter-policy to the export direction.

B.Configure route summarization on R2 and summarize routes as 10.0.0.0/16.

C.Configure route summarization on R3 and summarize routes as 10.0.0.0/16.

D.On R1, configure a filter-policy, use the ACL applied to the filter-policy to match 10.0.3.3/32, and apply the filter-policy to the import direction.

H12-261 Exam Question 43

What is the correct description of the reflector? Multiple BGP ( ) selection

A.In the absence of a route reflector, the relationship needs to be fully inter-IBGP neighbors, and the
introduction of route reflectors can reduce the requirement for full inter-connection.

B.The route reflector can advertise all IBGP client non-client neighbors from the learned route.

C.The route reflector can advertise all non-client clients from the learned routes.

D.The route reflector can advertise other client client non-client from a learned route.

H12-261 Exam Question 44

Established as shown below, R1.R2 E-BGP, BFD, neighbor and open function detection The following
method is correct

A.R1 BD 660ms text report detection time is

B.R2 BFD 800ms text report detection time is

C.R2 BFD 600ms text report detection time is

D.R1 BFD 1280ms text report detection time is

H12-261 Exam Question 45

For Huawei S series switches, to control which member switch becomes the master switch of a stack, first power on the switch you wish to be the master switch, and then wait 20 seconds before powering on the other member switches.

A.TRUE

B.FALSE

Other Version: 78Huawei.Exam-killer.H12-261.v2021-08-25.by.mortimer.151q.pdf

Latest Upload: 153CBIC.CIC.v2025-09-13.q75; 155Cisco.700-841.v2025-09-13.q131; 145SAP.C_ABAPD_2507.v2025-09-12.q56; 128SAP.C_TS452_2022.v2025-09-12.q83; 212ACSM.020-222.v2025-09-11.q48; 168VMware.5V0-31.23.v2025-09-10.q73; 138Oracle.1z0-915-1.v2025-09-10.q24; 174Citrix.1Y0-231.v2025-09-10.q87; 149SAP.C-THR85-2505.v2025-09-09.q29; 188Adobe.AD0-E727.v2025-09-09.q76

H12-261 Exam Question 41

H12-261 Exam Question 42

H12-261 Exam Question 43

H12-261 Exam Question 44

H12-261 Exam Question 45

Download PDF File