Which of the following statement about static routing in Huawei equipment is wrong?

A device has been configured to complete the Telnet configuration. The device login address is 10.1.1.10. The Telnet user name is admin and the password is Huawei@123. Which of the following is the correct way to log in to this device using telnetlib?

On Huawei switches, you can use the command vlan batch to create multiple VLANs in batches, simplifying the configuration process.

What is the maximum negotiation rate supported by the IEEE 802.llg standard?

The output information of a certain device is shown in the figure. Which of the following statements is correct? (Multiple Choice)
<Huawe1>display interface G1gabitEthernet 0/0/0
G1gabi tEthernet0/0/0 current state : UP
Line protocol current state : UP
Route Port, The Maximum Transmit Unit is 1000
Internet Address is 10.0.12.2/2 4
IP Sending Frames' Format is PRTFMT ETENT_2.Hardware address is 00e0- fc22- 4fff
Port Mode: FORCE COPPER
Speed : 100.Loopback: NONE
Duplex: FULL,Negotiation: DISABLE
Md1 : AUTO
Last 300 seconds input rate 24 bits/sec, 0 packets/sec
Last 300 seconds output rate 24 bits/sec, 0 packets/sec