IPv4 addresses are currently 32 bits long. IPv6 addresses are 128 bits long. Source: KRUTZ, Ronald L. & VINES, Russel D., The CISSP Prep Guide: Mastering the Ten Domains of Computer Security, 2001, John Wiley & Sons, Page 87.

Asynchronous Communication is the basic language of modems and dial-up remote access systems.
Source: KRUTZ, Ronald L. & VINES, Russel D., The CISSP Prep Guide: Mastering the Ten Domains of Computer Security, 2001, John Wiley & Sons, Page 100.

The reporting process should be centralized else employees won't bother.
The other answers are incorrect because :
They are afraid of being pulled into something they don't want to be involved with is incorrect as most of the employees fear of this and this would prevent them to report an incident.
They are afraid of being accused of something they didn't do is also incorrect as this also prevents them to report an incident. They are unaware of the company's security policies and procedures is also incorrect as
mentioned above.
Reference : Shon Harris AIO v3 , Ch-10 : Laws , Investigatio & Ethics , Page : 675.

Section: Access Control
Explanation/Reference:
A network sniffer captures a copy every packet that traverses the network segment the sniffer is connect to.
Sniffers are typically devices that can collect information from a communication medium, such as a network.
These devices can range from specialized equipment to basic workstations with customized software.
A sniffer can collect information about most, if not all, attributes of the communication. The most common method of sniffing is to plug a sniffer into an existing network device like a hub or switch. A hub (which is designed to relay all traffic passing through it to all of its ports) will automatically begin sending all the traffic on that network segment to the sniffing device. On the other hand, a switch (which is designed to limit what traffic gets sent to which port) will have to be specially configured to send all traffic to the port where the sniffer is plugged in.
Another method for sniffing is to use a network tap-a device that literally splits a network transmission into two identical streams; one going to the original network destination and the other going to the sniffing device. Each of these methods has its advantages and disadvantages, including cost, feasibility, and the desire to maintain the secrecy of the sniffing activity.
The packets captured by sniffer are decoded and then displayed by the sniffer. Therfore, if the username/ password are contained in a packet or packets traversing the segment the sniffer is connected to, it will capture and display that information (and any other information on that segment it can see).
Of course, if the information is encrypted via a VPN, SSL, TLS, or similar technology, the information is still captured and displayed, but it is in an unreadable format.
The following answers are incorrect:
Data diddling involves changing data before, as it is enterred into a computer, or after it is extracted.
Spoofing is forging an address and inserting it into a packet to disguise the origin of the communication - or causing a system to respond to the wrong address.
Smurfing would refer to the smurf attack, where an attacker sends spoofed packets to the broadcast address on a gateway in order to cause a denial of service.
The following reference(s) were/was used to create this question:
CISA Review manual 2014 Page number 321
Official ISC2 Guide to the CISSP 3rd edition Page Number 153