Up to 64 Ethernet interfaces can be grouped to form a LAG, and In a Junos Fusion, up to 1,000 LAGs are supported on QFX10002 switches acting as aggregation devices.
The LAG must be configured on both sides of the link.
The interfaces on either side of the link must be set to the same speed and be in full-duplex mode.

For a tunnel to be established, the endpoints must have a route to each other. This is essential for the encapsulated packets to reach their destination.
Tunnels encapsulate packets, adding extra headers for the encapsulation protocol, which increases the overall packet size.

An ISO NET address is a type of network address used by the IS-IS routing protocol. It identifies a point of connection to the network, such as a router interface, and is also called a Network Service Access Point (NSAP).
An ISO NET address consists of three parts: an area ID, a system ID, and a selector. The area ID identifies the IS-IS area to which the device belongs. The system ID uniquely identifies the device within the area. The selector identifies a specific service or function on the device, such as routing or management.
An ISO NET address must be unique for each device in the network, because it is used by IS-IS to establish adjacencies, exchange routing information, and compute shortest paths. If two devices have the same ISO NET address, they will not be able to communicate with each other or with other devices in the network. Therefore, it is important to assign different ISO NET addresses to each device in the network.