Online Access Free JN0-360 Exam Questions

You want to configure support for an IPv6 environment In which hierarchy would you configure an OSPF area?

• A.[edit protocols ipv6-ospf
• B.[edit protocols ipv6J
• C.[edit protocols ospf3]
• D.[edit protocols ospf-v6]

Which statement is true about the operation of Layer 2 VPNs?

• A.Layer 2 VPNs allow CEs to use different encapsulations on either side of the VPN
• B.Layer 2 VPNs do not permit CE devices to operate a Layer 3 protocol with each other
• C.Service provider routers must evaluate the IP header of packets as they traverse their network
• D.Layer 2 VPNs require that CE devices use the same Layer 2 encapsulation

You must configure an OSPF area that does not accept type 3 link-state advertisements
(LSAs) from area 0 (other than the default route) You have configured your area to be stub, but you still see type 3 LSAs.
What will account for this behavior?

• A.You have exported routes into OSPF
• B.You should have configured your area as totally stubby
• C.You are experiencing a routing loop
• D.You should have used a not-so-stubby-area

What are Martian addresses on a Junos device?

• A.IP addresses specifically used for out-of-band management.
• B.IP addresses that are reserved for use only with MPLS VPNs.
• C.IP addresses that are reserved for use only with GRE tunnels.
• D.IP addresses that are never installed in the routing table.

You are asked to configure a GRE tunnel between two remote sites to support the exchange of IPv6 traffic. The two sites are separated by an IPv4 network.
Which two configuration elements are required? (Choose two.)

• A.You must add a static route for the remote IPv6 destination subnet with the remote tunnel endpoint as the next hop at each site.
• B.You must enable the GRE interface for IPv6 operations.
• C.You must increase the MTU to no less than 2500.
• D.You must enable the GRE interface for IPv4 operations.