Online Access Free JN0-648 Exam Questions

Click the Exhibit button.

There is a functioning OSPFv3 neighborship between Router-1 and Router-2 over the ge-0/0/1 link. However, the 172.100.100.0/24 and 172.101.101.100/24 routes are not being shared through OSPFv3.
Referring to the configuration shown in the exhibit, which two actions must you take to solve the problem? (Choose two.)

• A.Add the IPv6 family protocol under ge-0/0/2 for both routers.
• B.Add interface ge-0/0/2 under OSPFv3 for both routers.
• C.Add the lo0 interface under OSPFv3 for both routers.
• D.Add interface ge-0/0/1 under the IPv4 unicast realm for both routers.

You have multiple BGP routes to the same prefix with equal local-preference values and AS-path lengths.
In this scenario, which route will be preferred in the route selection process?

• A.The route with the highest MED value.
• B.The route with the least preferred origin value.
• C.The route with the most preferred origin value.
• D.The route with the lowest MED value.

Click the Exhibit button.

Referring to the exhibit, you configured a new multifield classifier for the ge-1/2/0 interface to move ICMP traffic to the best-effort queue and traffic from 192.168.20.0/24 to the expedited forwarding queue. You received notice that some applications are not working after the change.
Which configuration change will remedy the problem?

• A.Option C
• B.Option D
• C.Option A
• D.Option B

A BA classifier, input policer, and a multifield classifier are applied to an interface in which order are these features processed?

• A.policer > multifield classifier -> BA classifier
• B.multifield classifier -> BA classifier -> policer
• C.BA classifier -> multifield classifier -> policer
• D.policer -> BA classifier -> multifield classifier

Your IPv4 multicast network uses different MX Series routers for the source DR and the PIM sparse-mode RP.
What is required before PIM register messages are exchanged between the DR and RP routers?

• A.Add a tunnel services PIC to the RP router.
• B.Add an adaptive services PIC to the DR router.
• C.Configure PIM encapsulation on the DR and RP routers.
• D.Enable tunnel services on the DR and RP routers.