Online Access Free JN0-664 Exam Questions

Exhibit

You want to use both links between R1 and R2 Because of the bandwidth difference between the two links, you must ensure that the links are used as much as possible.
Which action will accomplish this goal?

• A.Ensure that the metric-out parameter on the Gigabit Ethernet interface is higher than the 10 Gigibit Ethernet interface.
• B.Define a policy to tag routes with the appropriate bandwidth community.
• C.Enable per-prefix load balancing.
• D.Disable multipath.

Exhibit

Which two statements about the output shown in the exhibit are correct? (Choose two.)

• A.The connection has not flapped since it was initiated.
• B.There has been a VLAN ID mismatch.
• C.The PE is attached to a single local site.
• D.The PE router has the capability to pop flow labels

You are configuring a BGP signaled Layer 2 VPN across your MPLS enabled core network. Your PE-2 device connects to two sites within the s VPN In this scenario, which statement is correct?

• A.You must use separate physical interfaces to connect PE-2 to each site.
• B.By default on PE-2, the site's local ID is automatically assigned a value of 0 and must be configured to match the total number of attached sites.
• C.You must create a unique Layer 2 VPN routing instance for each site on the PE-2 device.
• D.By default on PE-2, the remote site IDs are automatically assigned based on the order that you add the interfaces to the site configuration.

Exhibit

Referring to the exhibit, which two statements are true? (Choose two.)

• A.The devices advertising this route into EVPN are 10 0 2 12 and 10.0.2.22.
• B.The device advertising this route into EVPN is 192.168.101.5.
• C.This is an EVPN Type-2 route.
• D.This route is learned through EBGP

You are using a Layer 3 VPN to connect two customer sites. The VPN routes for the customer networks appear as hidden in the bgp. 13vpn. o routing table on the PE routers.
What is causing this problem?

• A.There is a routing loop in the service provider backbone.
• B.Route targets are not configured.
• C.There is not an established MPLS LSP between the two PE routers.
• D.The routes use overlapping IP addresses.