Online Access Free NACE-CIP1-001 Exam Questions

Check abrasive blast pressure with a

• A.needle pressure gauge
• B.replica tape
• C.nozzle aperature gauge
• D.surface comparator

What is the minimum recommended distance away from an edge that an inspector should take a measurement with a dial-type magnetic pull-off Dry Film Thickness (DFT) gauge?

• A.6.35 cm (2.5 inch)
• B.2.5 millimeters (.10 inch)
• C.2.5 cm (1 inch)
• D.1 cm (.39 inch)

According to SSPC PA 2 a Spot Measurement is:

• A.The average of gauge readings taken in a 4cm (1.5 inch) circle
• B.A single gauge reading
• C.The average of all spot measurements in a given area
• D.The overall average of all readings

If a Thermoset coating is heated it will:

• A.Harden and return to its original hardness when cooled
• B.Soften when heated and retain its softness when cooled
• C.Soften when heated and return to its original hardness when cooled
• D.Harden and retain its hardness when cooled

Upon arrival of coating materials, the inspector should

• A.observe and document time frame and environmental conditions between each coat.
• B.observe aryl document that the applicator WFT at regular intervals during application.
• C.review coating contractors' plans for storage of coating materials and confirm they meet national, local and owners' fire and environmental regulations.
• D.observe and document the amount of material and batch numbers.