Online Access Free NS0-181 Exam Questions

A new AFF8200 has a four-port UTA2 adapter installed in slot 2. Using the ucadmin command, you see that these ports are configured for FC.
Which port names are correct in this scenario?

• A.e2a, e2b, e2c, e2d
• B.e0a/0a, e0b/0b, e0c/0c, e0d/od
• C.e2a/2a, e2b/2b, e2c/2c, e2d/2d
• D.2a, 2b, 2c, 2d

A customer is settings up a new cluster. The customer notices that there are many management ports on the cluster. The customer is know the purpose of the node management network LIF.
What do you tell customer in this scenario?

• A.The node management LIF is associated with a storage virtual machine (SVM) and is used for communicating with client.
• B.The node management LIF provides a dedicated IP address for the entire cluster and can fail over to any node management or data port in the cluster.
• C.The node management LIF provides a dedicated a IP address to managing a particular node in the cluster and is used for system maintenance.
• D.The node management LIF provides multiple IP address for managing a particular node in the cluster at the hardware level and is used for system maintenance.

You install and apply the NetApp RSCF on cluster interconnect switches.
Which two statements are correct in this scenario? (Choose two.)

• A.The RCF file enables jumbo frames for all cluster traffic.
• B.The RCF file enables flow control and is set to receive.
• C.The RCF file enables IPv6 for use by the cluster traffic.
• D.The RCF file enables CDP to allow connected devices to discover the switch.

You need to verify the configuration currently loaded on a Cisco Nexus 3132Q-V cluster switch after applying the RCF.
Which command will accomplish this task?

• A.Use the show startup-conf command.
• B.Use the verify config command.
• C.Use the show bootvar command.
• D.Use the show running-config command

You install a new AFF A300 2-node switchless cluster with ONTAP 9.1 at a customer site. Each node has a root aggregate as part of the system configuration.
In this scenario, what is the default disk partitioning called?

• A.root-data partitioning
• B.root-data-root partitioning
• C.root-data-data partitioning
• D.data-data partitioning