Online Access Free NS0-182 Exam Questions

While preparing for a new cluster installation, your customer indicates that they have some disk shelves and switches that were discontinued at their old site. They want to re-use as much of this equipment as possible.
You must verify that their discontinued equipment is compatible with the new equipment they have on order.
Which two actions will accomplish this task? (Choose two.)

• A.Use the Hardware Universe portal (HWU).
• B.Run the Cluster Configuration Builder tool (ConfigBuilder).
• C.Verify compatibility from Activity IQ.
• D.look up the compatibility in the Interoperability Matrix Tool (IMT).

When planning the installation of a new ONTAP 9.5 cluster for a customer, which three steps should you perform? (Choose three.)

• A.Open a support case to prepare for the installation.
• B.Search for Technical Support bulletins for the hardware.
• C.Review the hardware components in Hardware Universe.
• D.Complete a Service Event Report.
• E.Use Config Builder to create a configuration spreadsheet.

A customer ordered two new DS224C shelves. The customer wants you to add these shelves to an existing stack which consists of two DS2246 shelves.
Which statement is true in this scenario?

• A.Mixing DS224C and DS2246 shelves in the same node are not supported.
• B.You need to order additional cables to expand the existing stack.
• C.DS224C shelves are supports with only new HBAs.
• D.You cannot mix DS224C and DS2246 shelves in the same stack.

A customer wants you to add a new AFF A700 HA pair to an existing 4-node AFF8080 EX cluster. The existing cluster uses NetApp CN1610 switches for the cluster connection and is using the recommended port count.
Which statement is true in this scenario?

• A.There are not enough ports available on the cluster switch.
• B.You cannot have more than four nodes with AFF.
• C.You cannot mix different AFF models in the same cluster.
• D.The AFF A700 is not supported with NetApp CN1610 switches/

You are going to add a node to an existing cluster but first you must gather the appropriate information for the new node's management LIF.
What two pieces of information is required to accomplish this task? (Choose two.)

• A.NTP server address
• B.default gateway
• C.Service Processor Information
• D.IP address