Online Access Free NS0-194 Exam Questions

You have a 4-node cluster configured for FC. You create a new LUN on node 1, map the LUN to a host, and verify that the host is able to correctly access the LUN. However, after moving the LUN's volume to node 3, ALUA reports that all the paths are non-optlmized. You have already verified that all zoning and physical cabling is correct.
What should you do to enable ALUA to see the optimized paths?

• A.Update the igroup initiator WWPN.
• B.Update the MPIO policy to round-robin.
• C.Update the MPIO policy to most recently used.
• D.Update the reporting nodes for the LUN mapping.

Customers are accessing data that was mirrored from an ONTAP 9.3 system to an ONTAP 9.5 system using DP SnapMirror. Performance on the ONTAP 9.5 system is degraded.
In this scenario, what would cause this problem?

• A.The ONTAP 9.3 node's data is not fragmented.
• B.The ONTAP 9.5 node's data must be deswizzled.
• C.The ONTAP 9.5 node's using atraditional volume.
• D.The ONTAP 9.3 node's older Snapshot copies are causing performance problems.

Which two NetApp products are supported by the NetApp Kubernetes Service? (Choose two.)

• A.FlexPod
• B.E-Series
• C.NetApp HCI
• D.ONTAP Select

A customer is showing disk utilization is at 100% in Active IQ even though there are low protocol operations on the controller. You review the data shown in the exhibit.

In this situation, what should you do?

• A.Reseat shelf module B.
• B.Add disks to the aggregate to bring down the average utilization.
• C.Replace disks 6b.34 and 6a.19.
• D.Replace disk 6b.39.

Click the Exhibit button.

Referring to the exhibit, if Node loses power, what are two nodes where epsilon would move?
(Choose two.)

• A.Node D
• B.Node C
• C.Node
• D.Node A