Online Access Free NS0-507 Exam Questions

What are three considerations when creating a physical reference diagram of an FC SAN?
(Choose three.)

• A.Hardware is compatible
• B.FC switches are available
• C.Power connectivity is available
• D.FC SAN zoning is available
• E.FC port connectivity is available

An Administrator has an ONTAP 9.1 cluster. The cluster contains a number of volumes with data writes as shown in the exhibit. Adaptive compression is enabled, and the initial space savings that are shown are achieved. The administrator has enabled data compaction on the volumes.
Referring to the exhibit. How many ONTAP blocks would be used to hold the data after data compaction is enabled?

• A.11
• B.8
• C.6
• D.10

A LUN copy has been created by using the lun copy command.
To allow the copy to be seen on the same host, what would you do?

• A.Configure SLM on the new node.
• B.Map the LUN to the same igroup.
• C.Change the serial number of the copied LUN.
• D.Create a new portset.

You are deploying iSCSI on a newly installed ON TAP cluster. Your network administrator has provided you with 10 Gb network links and physically connected them to your nodes.
According to NetApp best practice, which two network settings should you configure to optimize performance? (Choose two.)

• A.Enable jumbo frames.
• B.Disable jumbo frames.
• C.Disable Ethernet flow control for all ports.
• D.Use single initiator, multiple target zoning.

You need to perform a DR test on a FAS8200 with SAN LUNs using the onboard UTA2 with 16Gb SFP+.
In this scenario, what is the minimum port speed required on the DR Site's FC switches?

• A.8 Gb
• B.4 Gb
• C.2 Gb
• D.16 Gb