Online Access Free 1z1-400 Exam Questions

According to the Acme Packet Best Current Practice (BCP), when configuring High Availability on a Session Border Controller pair, what two critical steps must be completed?

• A.Synchronize the configurations and system states between the two systems via the sync-config and sync-state commands, followed by the save-configuration and activate-configuration commands.
• B.Configure the Border Element Redundancy Protocol (BERP) between the two peers by specifying a BERP peer address, a BERP timeout, and a BERP failover threshold.
• C.Devise a virtual MAC scheme for the redundant cluster.
• D.Connect the HA-serial 1 and HA-serial 2 RS-232 interfaces together to provide state replication and heartbeat polling between the two systems.
• E.Configure the target names of the two systems.

Which two parameters are NOT phy-interface parameters?

• A.hostname
• B.speed
• C.name
• D.operation-type
• E.sub-port-id

When SNMP access is enabled to the Session Border Controller, which statement is TRUE?

• A.Only one trap receiver can be configured.
• B.The default community strings are acme and packet.
• C.Community strings are in passive mode.
• D.There are no default community strings.
• E.The default community strings are public and private.

In high availability (HA) architectures, requests from the standby node result in information about state changes being pulled by the standby Session Border Controller (SBC) from the active SBC.Two checkpointed states include:

• A.Signaling state
• B.Media state
• C.Dormant state
• D.Alarm state
• E.Admin state

To view an existing multiple-instance element's configuration you can go to the correct branch of the configuration tree and___________.

• A.Select the element and then issue the show command.
• B.Typeis -a.
• C.Type show ?and select from the displayed list.
• D.Type show <element name>.
• E.Enter the name of the element and then issue the show command.