Online Access Free 1z1-404 Exam Questions

Which two statements are correct about configuring realms and their corresponding interfaces? (Choose two.)

• A.You can associate multiple realms with a single networkinterface.
• B.Although you can use both TCP and UDP concurrently as the transport protocol, you can only have one SIP interface per realm.
• C.You can associate multiple network interfaces with a single realm only when either TCP or UDP is used as the transport protocol.
• D.You can configure more than one SIP interface per realm.
• E.You can associate multiple home realms with a single network interface.

The Session Border Controller needs to be configured to act as a Back-to-Back User Agent
(B2BUA).
How would you accomplish this?

• A.Navigate to the session-router configuration element and set the operation-mode to dialog.
• B.Navigate to the sip-configconfiguration element and set the operation-mode to dialog.
• C.Navigate to the sip-config configuration element and set the operation-mode to stateless.
• D.Navigate to the session-router configuration element and set the operation-mode to none.
• E.Navigate to the sip-config configuration element and set the operation-mode to stateful.

To ensure proper operation of a Session Border Controller HighAvailability (HA) pair, it is critical that both of the devices can originate legitimate traffic on media interfaces independent of the network interface IP address.
How is this type of traffic accommodated?

• A.by setting the utility address and sec-gateway values to addresses in different subnets as the IP address configured on the wancom interfaces
• B.via the utility address parameters on the wancoml and wancom2 interfaces
• C.by setting a unique address on the wancoml and wancom2 interfaces via the utilityaddress command
• D.by setting the pri-utility-addr, sec-utility-addr, and sec-gateway values to addresses in the same subnet as the IP address configured on the media interfaces
• E.by setting the pri-utility-addr, sec-utility-addr, and sec-gateway values to addresses in the same subnet as the IP address configured on the management interfaces

You want to view an existing multiple-instance element's configuration.
What step should you perform after you go to the correct branch of theconfiguration tree?

• A.Enter the name of the element and then issue the show command.
• B.Type show ? and select from the displayed list.
• C.Type is -a.
• D.Type show <element name>.
• E.Select the element and then issue the show command.

Which three options are valid ways to apply Header Manipulation Rules (HMRs) to your existing configuration?

• A.Navigate to the session-agent configuration element and configure the in-manipulationid parameter.
• B.Navigate to the sip-interface configuration element and configure the in-manipulationid parameter.
• C.Navigate to the network-interface configuration element and configure the in- manipulationid parameter.
• D.Navigate to the session-group configuration element and configure the in-manipulationid parameter.
• E.Navigate to the session-agent configuration element and configure the in-manipulationid parameter.