Online Access Free C-IBP-1908 Exam Questions

ADVANCED ANALYTICS AND REPORTING
Key figure DISACC is using key figures KFI and KF2 in the disaggregation expression.
What properties are valid for these key figures?

• A.DISAGG can be a Snapshot key figure.
• B.KFI and KF2 can be Alert key figures.
• C.KFI and KF2 can be Snapshot key figures.
• D.DISACC can be an Alert key figure.

New key figures were introduced. You can use them in the IBP Excel add-in to set the maximum supply quantity to be transferred, purchased, or produced. If constraints make it impossible to reach this upper limit, as much as possible will be transferred, purchased or produced. If you set this value to 0, then this is the maximum supply quantity. The following are the new key figures in the SAP7 sample planning area:
Note: There are 2 correct answers to this question

• A.Adjusted Distribution Receipt (Lane) (ADJUSTEDDISTRRECEIPTLXNE): this is a stored key figure containing the adjusted value for the receipt quantity of a material distributed from a ship-from location of the type plant to a ship-to location of the type plant. If mapped to the corresponding business meanings, it can be used to adjust the number of stock transfers and purchases.
• B.Adjusted Production Receipt (PDS) (ADJUSTEDPRODRECEIPTPDS): this is a stored key figure containing the adjusted value for a production quantity for a specific production data source.
• C.For-matting in Microsoft Excel planning view chart.

What are the main outputs that are calculated by the SAP Integrated Business Planning for Inventory?
Note: There are 3 correct answers to this question.

• A.Minimum internal service level
• B.On-hand stock
• C.Recommended safety stock
• D.Reorder point
• E.Projected stock

GENERAL CONFIGURATION OF A PLANNING AREA
You try to activate a master data type where you added a key attribute and receive the following error message: "Cannot add attribute & 1 as key attribute." What could be the reason?

• A.Data already exists for the master data type and NO data is available yet for the new key attribute
• B.The attribute is a decimal data type so it CANNOT be used as a key attribute in the master data.
• C.The master data type is a simple master data and CANNOT have more than 1 key attribute.
• D.The attribute was set up as an attribute as key figure and CANNOT be used as a key attribute.

GENERAL CONFIGURATION OF A PLANNING AREA
What happens when an ID and an attribute description are linked?
Note: There are 3 correct answers to this question.

• A.Downloaded data volume during logon to Microsoft Excel is reduced.
• B.Descriptions must be included in the planning area before you can use them in Microsoft Excel
• C.Descriptions must be included in the planning levels before you can use them in Microsoft Excel.
• D.Both description and ID can be displayed in the same field in Microsoft Excel.
• E.Sorting is always by ID, regardless if you select ID or description in Microsoft Excel.