Online Access Free 3V0-41.19 Exam Questions

An architect is helping an organization with the Physical Design of an NSX-T Data Center solution. This information was gathered during a workshop:
* Current hypervisor of choice is KVM.
* Cost reduction is important.
Which two should the architect recommend to the organization? (Choose two.)

• A.Deploy NSX Manager using QCOW2.
• B.Deploy NSX Manager using OVF.
• C.Deploy bare metal Edge Nodes.
• D.Deploy Edge VM Nodes on KVM.
• E.Deploy Edge VM Nodes using ISO.

An architect is helping an organization with the Physical Design of an NSX-T Data Center solution. This information was gathered during a workshop:
* Some workloads should be moved to a CloudProvider.
* Extend network's VLAN or VNI across sites on the same broadcast domain.
* Enable VM mobility use cases such as migration and disaster recovery without IP address changes.
* Support 1500 byte MTU between sites.
Which should thearchitect include in their design?

• A.Load Balancer
• B.SSL VPN
• C.L2 VPN
• D.Reflexive NAT

An architect is helping an organization with the Logical Design of an NSX-T Data Center solution. This information was gathered during the assessment:
* There must be a performance based SLA for East - West traffic.
Which two key performance features should the architect recommend? (Choose two.)

• A.Leverage DPDK drivers.
• B.Configure N-VDS Enhanced Data Path.
• C.Setup RSS to leverage multiple cores.
• D.Enable GENEVE-Offload.
• E.Install advanced Edge pNIC Features.

An architect is helping an organization with the Physical Design of an NSX-T Data Center solution. This information was gathered during a workshop:
* There are six hosts and hardware has already been purchased.
* Customer is planning a collapsed Management/Edge/Compute cluster.
* Each host has two 10Gb NICs connected to a pair of ToR switches.
* There should be no single point of failure in any proposed design.
Which virtual switch design should the architect recommend to the organization?

• A.Create a vSphere Distributed Switch (vDS) for Management VMkernel traffic and assign one NIC.
  Also, create an NSX-T Virtual Distributed Switch (N-VDS) for overlay traffic and assign one NIC.
• B.Create an NSX-T Virtual Distributed Switch (N-VDS) for Management VMkernel and overlay traffic and assign both NICs.
• C.Create an NSX-T Virtual Distributed Switch (N-VDS) for Management VMkernel traffic and assign one NIC. Also, create an NSX-T Virtual Distributed Switch (N-VDS) for overlay traffic and assign one NIC.
• D.Create an NSX-T Virtual Distributed Switch (N-VDS) for Management VMkernal and overlay traffic and assign a new virtual NIC.

Refer to the exhibits.
An architect is helping an organization with the Conceptual Design of an NSX-T Data Center solution. The conceptual design includes these requirements, assumptions, constraints, and risks:
* Critical applications must run across sites without changing IP address.
* Business continuity and disaster recovery (BCDR) plans will leverage a second site running vSphere.
* RTO/RPO must be reduced for recovery of applications on secondary site.
* IT Teams require automation tools for configuration.
Which Conceptual Design would the architect recommend to the customer?

• A.Design Option 4
• B.Design Option 1
• C.Design Option 3
• D.Design Option 2