Online Access Free VCP-410 Exam Questions

An administrator uses VMware vCenter Data Recovery to make backups of virtual machines. Checking on the backup jobs run the previous evening, the administrator notices some jobs completed while others did not. Which of the following are possible causes for the failure (Choose Two)?

• A.The deduplication store had 4GB of available space prior to the start of the affected jobs.
• B.CPU utilization on one or more ESX/ESXi hosts exceeded 90 percent prior to one or more jobs executing.
• C.Four backup jobs were running simultaneously, causing new jobs to fail to start.
• D.Four restore jobs were running simultaneously, causing new jobs to fail to start.

An administrator is configuring a VMware HA Cluster for three ESXi Hosts and their resident virtual machines. The HA cluster will be configured to support a single host failure and resource reservations must be enforced during a failover event. Assuming default settings, how does HA determine the current failover capacity?

• A.Using the highest CPU Reservation and the Available Memory values for any given virtual machine in the cluster
• B.Using the highest CPU Reservation and Memory Reservation values of any given virtual machine in the cluster
• C.Using an average of the total CPU Reservation and Memory Reservation values of all virtual machines in the cluster
• D.Using an average of the total CPU Reservation and Available Memory values of all virtual machines in the cluster

When attempting to vMotion migrate a newly built virtual machine, the migration fails. Which of the following conditions could explain the cause of the failed migration (Choose Two)?

• A.The VM has an active snapshot.
• B.NPIV has been enabled on the VM, and vMotion is not supported with NPIV.
• C.VMI Paravirtualization Support has been enabled for the VM, but is not supported on the target ESX/ESXi host.
• D.Insufficient CPU resources are available on the destination ESX/ESXi host.

An administrator is upgrading two ESX 3.5 Hosts using the vSphere Host Update Utility. A second administrator launches the utility, intending to upgrade the first host. Which of the following is true about this scenario (Choose Two)?

• A.Performing upgrades on multiple hosts simultaneously is not supported
• B.The vSphere Host Update Utility will indicate that the existing upgrade is in process and abort
• C.The vSphere Host Update Utility will not show that an upgrade is already in progress
• D.Multiple simultaneous upgrades are supported, but only in deployments with 10 or fewer hosts

An administrator is installing an ESX host to boot from a SAN LUN. During installation, the ESX device drivers are unable to detect the HBA. Which of the following could be the issue?

• A.The HBA is connected to an active/passive storage array, but the configured port is passive.
• B.The HBA is not plugged into the lowest PCI bus and slot number.
• C.The HBA is connected to a SAN using a direct connect topology.
• D.The HBA BIOS is not enabled.