Online Access Free VCS-273 Exam Questions

What should an administrator do to enable backups to span multiple BasicDisk storage units?

• A.configure a storage unit group that consists only of disk storage units defined on a single Media Server
• B.confirm that a load balancing storage unit is selected at the group level
• C.select Storage Units > Storage Unit > Allow backup to span disks
• D.configure a storage unit group and add BasicDisk storage units from multiple Media Servers

An administrator is running an appliance upgrade from 2.6.0.1 to 2.6.1 and the appliance Web UI is inaccessible throughout the upgrade process.
How should the administrator check the progress of the upgrade using the CLISH?

• A.Manage > Software > UpgradeCheck
• B.Manage > Software > UpgradeProgress
• C.Manage > Software > UpgradeState
• D.Manage > Software > UpgradeStatus

An administrator wants to review the throughput of backup clients to improve performance.
Which area of the NetBackup Administration Console displays the throughput of backups for all clients?

• A.All Log Entries
• B.Status of Backups
• C.Device Monitor
• D.Client Backups

An administrator took Media Server, mediaA, offline for maintenance and set up a new Media Server, mediaB, with access to the previously backed up data. When restores are performed for data that was backed up by mediaA, the restores fail.
Which setting in the Host Properties must the administrator modify to allow successful restores?

• A.Verify both Media Servers are set up in the Media Server Host Properties > Restore Failover section.
• B.In the BAR GUI, change the "Server to use for backup and restores" setting to MediaB.
• C.From the Master Server, run the bpimage command to change the name of the Media Server from mediaA to mediaB.
• D.Verify both Media Servers are set up in the Master Server Host Properties > Restore Failover section.

An administrator working offsite is required to carry out a major upgrade to a NetBackup appliance. The appliance will need to be rebooted multiple times during the upgrade process.
How should the administrator connect to the appliance?

• A.connect to the IPMI interface using a web browser
• B.connect to the IPMI interface using the appliance web UI
• C.connect to the serial interface remotely using SSH
• D.connect to the serial interface remotely using CLISH