SYO-501 Exam Question 21
A remote user (User1) is unable to reach a newly provisioned corporate windows workstation.
The system administrator has been given the following log files from the VPN, corporate firewall and workstation host.
Which of the following is preventing the remote user from being able to access the workstation?
The system administrator has been given the following log files from the VPN, corporate firewall and workstation host.
Which of the following is preventing the remote user from being able to access the workstation?
SYO-501 Exam Question 22
A network administrator is trying to provide the most resilient hard drive configuration in a server. With five hard drives, which of the following is the MOST fault-tolerant configuration?
SYO-501 Exam Question 23
After a routine audit, a company discovers that engineering documents have been leaving the network on a particular port. The company must allow outbound traffic on this port, as it has a legitimate business use. Blocking the port would cause an outage. Which of the following technology controls should the company implement?
SYO-501 Exam Question 24
An organization is developing its mobile device management policies and procedures and is concerned about vulnerabilities associated with sensitive data being saved to a mobile device, as well as weak authentication when using a PIN As part or discussions on the topic several solutions are proposed Which of the following controls when required together, will address the protection of data at-rest as well as strong authentication?
(Select TWO).
(Select TWO).
SYO-501 Exam Question 25
A security engineer is setting up passwordless authentication for the first time.
INSTRUCTIONS
Use the minimum set of commands to set this up and verify that it works. Commands cannot be reused.
If at any time you would like to bring back the initial state of the simulation, please click the Reset All button.
INSTRUCTIONS
Use the minimum set of commands to set this up and verify that it works. Commands cannot be reused.
If at any time you would like to bring back the initial state of the simulation, please click the Reset All button.
