GB0-371-ENU Exam Question 111
As shown in the figure, there are two group member hosts Client1 and 3 running different versions of the IGMP protocol on the shared network segment, and there is also an IGMPV2 router Router, then the following statement is correct


GB0-371-ENU Exam Question 112
Multicast applications are based on UDP, so multicast applications have the following shortcomings
GB0-371-ENU Exam Question 113
Two routers RTA and RTB are connected through a LAN to form a VRRP backup group. The configuration of each interface is as follows:
GigabitEthernet1/0.1 of RTA
vlan-type dot1 q vid 2
ip address 192.168.0.252 255.255.255.0
vrrp vrid 1 virtual-ip 192.168.0.254
vrrp vrid 1 priority 120
GigabitEthernet1/0.2 of RTA
vlan-type dot1 q vid 3
ip address 192.168.1.252 255.255.255.0
vrrp vrid 2 virtual-ip 192.168.1.254
vrrp vrid 2 priority 120
GigabitEthernet1/0.1 of RTB:
vlan-type dot1 q vid 2
ip address 192.168.0.253 255.255.255.0
vrrp vrid 1 virtual-ip 192.168.0.254
GigabitEthernet1/0.2 of RTB:
vlan-type dot1 q vid 3
ip address 192.168.1.253 255.255.255.0
vrrp vrid 2 virtual-ip 192.168.1.254
The IP addresses of HostA and HostB in the LAN are 192.168.0.1 and 192.168.1.1 respectively. From the above information, we can know
GigabitEthernet1/0.1 of RTA
vlan-type dot1 q vid 2
ip address 192.168.0.252 255.255.255.0
vrrp vrid 1 virtual-ip 192.168.0.254
vrrp vrid 1 priority 120
GigabitEthernet1/0.2 of RTA
vlan-type dot1 q vid 3
ip address 192.168.1.252 255.255.255.0
vrrp vrid 2 virtual-ip 192.168.1.254
vrrp vrid 2 priority 120
GigabitEthernet1/0.1 of RTB:
vlan-type dot1 q vid 2
ip address 192.168.0.253 255.255.255.0
vrrp vrid 1 virtual-ip 192.168.0.254
GigabitEthernet1/0.2 of RTB:
vlan-type dot1 q vid 3
ip address 192.168.1.253 255.255.255.0
vrrp vrid 2 virtual-ip 192.168.1.254
The IP addresses of HostA and HostB in the LAN are 192.168.0.1 and 192.168.1.1 respectively. From the above information, we can know
GB0-371-ENU Exam Question 114
Drag and drop


GB0-371-ENU Exam Question 115
As shown in the network topology, if STP is enabled on SWA and SWD, the statement about SWA and SWD port status changes is correct.

